岩石抗拉强度是岩石力学的重要参数,也是岩体工程设计与稳定性评价的关键指标。为对比不同试验方法下岩石抗拉强度及其破坏机理,选取多种典型岩石,分别开展巴西劈裂与三点弯试验,同时结合声发射与数字图像技术(DIC)对加载过程中的损伤演化进行监测。结果表明:(1)三点弯得出的强度为抗折强度,但岩石本质上也是拉伸破坏,其强度约为巴西劈裂强度的2.5倍,其变形模量也高于巴西劈裂法;(2)两种试验在加载初始阶段声发射信号均较弱,在接近破坏时信号急剧上升,与破坏过程表现出良好的对应关系;(3)受应力状态差异影响,巴西劈裂试验中岩石处于拉-压耦合状态,裂纹由圆盘中部起裂并沿加载直径扩展;三点弯试验中梁体下缘近似单轴受拉,裂纹由下缘中部偏两侧萌生并向上扩展,二者在变形模式与破坏机理上存在本质差异。
Rock tensile strength is a fundamental parameter in rock mechanics and a key index for rock engineering design and stability evaluation. To compare tensile strength and failure mechanisms obtained from different test methods, representative rock types were tested using Brazilian splitting and three-point bending, with acoustic emission and digital image correlation (DIC) employed to monitor damage evolution. The test results show that:(1) The strength derived from three-point bending is the flexural strength, but the rock fails essentially in tension. Its strength is about 2.5 times of the strength from Brazilian split test, and its deformation modulus is higher than that from Braziliansplit testing. (2) The acoustic emission signals of both Brazilian splitting and three-point bending tests are weak in the initial loading stage. The signals rise sharply when approaching the crack initiation stage, which show a good correspondence with the damage process. (3) Due to differences in stress states, Brazilian splitting induces a tensile-compressive stress coupling, with cracks initiating at the disk center and propagating along the loading diameter, whereas three-point bending produces an approximately uniaxial tensile state at the beam bottom, where cracks initiate near the mid-span and propagate upward. These results demonstrate essential differences in deformation behavior and failure mechanisms between the two methods.
[1] Hudson J A, Brown E T, Rummel F. The controlled failure of rock discs and rings loaded in diametral compression[J]. International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 1972, 9(2):241-244.
[2] 喻勇. 质疑岩石巴西圆盘拉伸强度试验[J]. 岩石力学与工程学报, 2005, 24(7):1150-1157.
[3] 李海波, 张君伟, 邵蔚, 等. Bukit Timah 花岗岩的动态拉伸力学特性实验研究[J].岩土力学,2002,23(增1):1-4.
[4] 李炜, 尹建国. 一种测试岩石拉伸和压缩弹性模量的方法[J]. 岩土力学, 1998, 19(3):93-96.
[5] 杨同, 王宝学, 高谦, 等. 岩石弯曲拉伸试验研究[J]. 勘察科学技术, 2004(6):3-5, 53.
[6] 何满潮, 胡江春, 熊伟, 等. 岩石抗拉强度特性的劈裂试验分析[J]. 矿业研究与开发, 2005, 25(2):12-16.
[7] Fuenkajorn K, Klanphumeesri S. Laboratory determination of direct tensile strength and deformability of intact rocks[J]. Geotechnical Testing Journal, 2010, 34(1):97-102.
[8] Gong F, Zhang L, Wang S. Loading rate effect of rock material with the direct tensile and three Brazilian disc tests[J]. Advances in Civil Engineering, 2019:6260351.
[9] 黄正均, 任奋华, 李远, 等. 不同试验方法下岩石抗拉强度及破裂特性[J]. 实验技术与管理, 2020, 37(10):45-49.
[10] 张军, 牟晋智, 潘哲君, 等. 巴西圆盘拉伸强度测试在岩石力学中的发展综述及新见解[J]. 石油科学通报, 2024, 9(2):240-259.
[11] Liu J F, Wang C P, Wang L, et al. Tensile failure and acoustic emission characteristics of rock salt under different tensile testing conditions[J]. Journal of Central South University, 2023, 30(4):1345-1358.
[12] 许海亮,任合欢,宋义敏.带裂纹花岗岩试件三点弯变形演化及破裂机制[J].地下空间与工程学报,2022,18(4):1199-1207, 1218.
[13] Miao S, Pan P Z, Yu P, et al. Fracture analysis of Beishan granite after high-temperature treatment using digital image correlation[J]. Engineering Fracture Mechanics, 2019, 225(1-2):106847.
[14] Lu Y, Li W, Wang L, et al. In-situ microscale visualization experiments on microcracking and microdeformation behaviour around a pre-crack tip in a three-point bending sandstone[J]. International Journal of Rock Mechanics and Mining Sciences, 2019, 114:175-185.
[15] Li B Q, Einstein H H. Comparison of visual and acoustic emission observations in a four point bending experiment on barre granite[J]. Rock Mechanics and Rock Engineering, 2017, 50:2277-2296.
[16] Zhao T, Zhang W, Gu S, et al. Study on fracture mechanics of granite based on digital speckle correlation method[J]. International Journal of Solids Structures, 2020, 193-194:192-199.
[17] 许江, 宋肖徵, 彭守建, 等. 基于3D-DIC技术岩石广义应力松弛特性试验研究[J]. 岩土力学, 2021, 42(1):27-38.
[18] 易婷,唐建新,王艳磊.裂隙倾角及数目对岩体强度和破坏模式的影响[J].地下空间与工程学报,2021,17(1):98-106, 134.
[19] 黄鹏, 郑齐, 闫寒, 等.干湿循环和高温对砂岩宏细观特征影响研究[J].地下空间与工程学报,2025,21(增1):136-143.
[20] 张燕, 于大伟, 叶剑红. 岩石类材料拉伸弹性模量测量方法的对比研究[J]. 岩土力学, 2018, 39(6):2295-2303.
[21] Li D Y, Wong L N Y. The Brazilian disc test for rock mechanics applications:review and new insights[J]. Rock Mechanics and Rock Engineering, 2013, 46:269-287.
[22] Qi S, Lan H, Martin D, et al. Factors Controlling the Difference in Brazilian and Direct Tensile Strengths of the Lac du Bonnet Granite[J]. Rock Mechanics and Rock Engineering, 2020, 53(3):1005-1019.
[23] Luong M P. A new test for tensile strength measurement[J]. Géotechnique, 1986(34):69-74.